Need help?Do you have a question about the Harman Kardon HK730 and is the answer not in the manual?
General| Power Output | 40 watts per channel into 8Ω (stereo) |
|---|---|
| Tuning range | FM, MW |
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 0.1% |
| Damping factor | 40 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Impedance | 4Ω to 16Ω |
Explains the manual's organization for rapid, simple, and accurate installation and use of the receiver.
Discusses initial setup, serial number recording, and ensuring proper ventilation for heat dissipation.
Details recommended wire gauge, preparation, and identifying conductors for speaker connections.
Guides connecting speakers to SPEAKER SYSTEM 1 and 2, emphasizing phasing and impedance.
Explains connecting record players, including signal and ground cables, to PHONO 1 and 2 inputs.
Details connecting FM/AM antennas, including wire types, transformers, and placement.
Guides connecting tape decks for recording/playback using TAPE and TAPE MON inputs/outputs.
Explains connecting auxiliary inputs (AUX 1/2) and other components via PREAMP OUT/MAIN AMP IN.
Details using FUNCTION, VOLUME, BALANCE, and SPKRS-1 for basic record playback.
Describes checking speaker phasing and resolving audible hum issues.
Explains tuning FM stations, using controls like FUNCTION, TUNING, and FM MUTING.
Details how the MUTE ADJ control affects interstation noise muting.
Explains TREBLE, BASS, CONTOUR, HI CUT, LO CUT, MONO, and PHONES functions.
Covers circuit breakers, fuse replacement, and dial glass cleaning for safety and upkeep.
To Next Page