Software upgrade Instruction& Reset Procedure
1) Restore factory setting
①Long press Preset 1& Bluetooth (>10S) ，Reset to factory default. (Both DAB/FM model and FM model for user)；
Below only for FM model:
②Long press Preset 1 & Scan(>3S) ，Set FM REGION 1 range(50KHZ steps)，Reset to factory default. (FM model only)
③Long press Preset 2 & Scan(>3S) ，Set FM REGION 2 range(100KHZ steps)，Reset to factory default. (FM model only)
④Long press Preset 3 & Scan(>3S) ，Set FM REGION 3 range(Japan 100KHZ steps)，
Reset to factory default. (FM model only)
.
2) Check software version
1)long press the preset1 & preset5(>10s)，the device will voice out the firmware version. And at the same time, the LCD
display the software version. Note: for the DAB or BT firmware, each is divided into FM version and DAB version.
For example:
Tuner 2 DAB version ：T2 - DD: 0017 ； (DAB firmware version)
T2 - BD: 0020 ； (BT firmware version)
Tuner 2 FM version ： T2 - DF: 0017 ； (DAB firmware version)
T2 - BF: 0020 ； (BT firmware version)
2) it will exit the version display mode after voice version finished.
3) Software Upgrade
一、DAB FIRMWARE UPGRADE GUIDE:
1. Connect USB cable between PC and JBL TUNER XL.
2. Press the power button to power on JBL TUNER XL.
3. Long press Preset 5 & DAB (>10S), enter DAB upgrade mode. The screen will scroll “connect to PC or MAC then
copy update file”. Entering F/W Update Mode.
4. Copy F/W binary file into USB removable disk.
5. Disconnect USB device (by remove USB cable or eject USB device).
6. Wait until F/W update was finished. ---the LCD display “update done “and then it will power cycle by itself.
二、BT FIRMWARE UPGRADE GUIDE:
1. Plug USB burn line in DUT, DUT connect to PC by USB burn line.
2. Long press Preset 1 & Preset 5 & BT Button (>=10s) enter BT DFU mode in DUT.
3. Run SPTestTool.exe in PC.
4. Burn image as follows 1-5 steps of screen capture.
5. When the the Tool display “PASSED”, the upgrade done.
To Next Page
Loading...
