Harman Kardon design philosophy 
The TC Series amplifiers employ the key 
Harman Kardon design principles of high- 
instantaneous current capability (HCC), 
ultrawidebandwidth, low negative feedback, 
and fully discrete preamp and output 
circuitry. 
HCC  (High-instantaneous 
Current Capa,bility) 
While reproducing dynamic music 
signals, the instantaneous impedances of 
nearly all loudspeakers drop to less than a 
third of the nominal rating.  These low 
momentary impedances typically require 
three to six times more current from the 
amplifier than would a nominal Cohm 
resistive load.  The TC600 amplifier can 
supply 100 amperes of instantaneous 
current, while the TC300 and TC304 can 
supply 50 amperes.  This HCC provides 
control over the low impedance and 
fluctuating phase angles produced by 
normally operating speakers, ensuring 
that your speakers will be able to continu- 
ally reproduce the entire dynamic range 
of music without premature clipping or 
current limiting. 
Bridgeable 
All TC Series amplifiers are designed to 
provide increased power into 
2 
ohms 
stereo or 
4 
ohms bridged.  Unlike many 
lower-quality amplifiers, the TC Series 
amplifiers can 
be 
bridged for increased 
power.  Stable, reliable operation in these 
higher power modes is assured by the TC 
Series' wide-margin Safe Operating Area 
(S.O.A.), which anticipates the toughest 
operating conditions. 
Ultrawidebandwidth 
Unlike conventional automotive amplifi- 
ers, the TC600, TC300, and TC304 can 
reproduce musical frequencies ranging 
from less than  lOHz to more than 
100kHz.  This ultrawidebandwidth  im- 
proves the accuracy of reproduction of 
transient signals and ensures phase linear- 
ity. 
Low 
negative feedback 
This design philosophy is used by the 
world's most exclusive amplifiers.  It 
requires the highest quality internal 
components, and results in an extremely 
stable amplifier with unmeasurable TIM 
distortion and absolutely outstanding 
imaging characteristics. 
Fully discrete circuitry 
Rather than employing inexpensive 
integrated circuits, which reduce band- 
width and increase required negative