Harman Kardon TD420 - Page 5

1. Power Switch
Press to turn unit on/off
2. Record/Pause
Puts cassette deck in Record ready or
pause mode.
3. Play
Begins playback or recording.
4. Stop
Stops tape transport in any mode.
5. Rewind/Fast Forward
Rapidly rewinds/advances tape.
6. Record Mute
Inserts blank space when recording.
7. Intro Scan
Previews each segment on a
pre-recorded tape.
8. Search Foreward and
Reverse
Locates the start of any desired
segment on a pre-recorded tape. (See
page #5)
9. Doiby NR
Activates Dolby Noise Reduction
circuitry for playing or recording tapes.
Controls and Displays
10.
B/C
|
20)
Selects
Dolby
B
or
Dolby
C
Noise
Reduction.
11. MPX Filter
Press when recording FM stereo
broadcasts using Dolby noise reduction.
12.
Bias
Fine
Trim
“35
-20
-10
-7
Adjust
when
recording.
(See
page
#6)
—
a a
|
n.0
13.
Balance
ood
Adjusts balance between left and right
channels when recording.
14. Record Level
Adjusts recording level.
15. Open/Close
Press to load/remove tape cassette.
19. D0 BC
Shows if Dolby B or C circuits are on.
16. Cassette
Compartment/Drawer
20.
Counter
Indicates tape position in minutes and
17. Counter Reset seconds.
Resets Tape Counter to 00:00.
21. Level
Shows signal level.
18. CD Sync
Engage when synchronizing recording
with a Harman Kardon CD Player.
|
INTRO REC PLAY << a
MPX TYPE IIIIV mBCS
(9)
22. Intro
Indicates Intro Scan is engaged.
23. REC, PLAY,
Displays operating mode: Record, Play,
Rewind or Fast Forward.
24. TYPE I IIV
Automatically indicates type of tape in
use.