Harman Kardon TD4200 - General Instructions; Power Supply; Cabinet Service and Safety

GENERAL INSTRUCTIONS
Power Supply
Always use the correct AC voltage, connect
the power cord to a domestic mains outlet.
Never connect the unit to an outlet supply-
ing a higher voltage. This may create a fire
hazard.
Note for Customers other than Canada
This cassette deck is supplied with a
voltage selector enabling selection be-
tween 220V and 240V on the rear panal. If
the selector is not set to the local voltage,
set the selector to the correct voltage with a
screwdriver before connecting the power
cord to a mains outlet.
Handle the Power Cord Genily
B Todisconnect the plug from the AC
outlet, pull on the piug itself, not on the
cord. Pulling the cord may break the
wire.
RB Disconnect the plug from the AC outlet
whenever the unit is to be left unused
for an extended period of time.
@ Do not place furniture or other heavy
objects on the cord, and avoid dropping
heavy objects on it. Also do not make a
knot in the cord; this can damage it and
cause a fire hazard.
Place of Installation
Place the cassette deck on a firm and level
surface. Avoid installing it:
@ = In moist or humid places; *
™ Close to heating equipment or in places
exposed to direct sunlight;
@ Ina direct draft from an air conditioner
or in other very cold locations;
@ In places subject to excessive vibration
or dust;
@ in poorly ventilated places.
Moving the Unit
Before moving the unit, be sure to unplug
the power cord and disconnect all wires to
other stereo components.
Do Not Open the Cabinet
Except for performing routine maintenance
(see Page 10), do not attempt to service this
unit. Tampering with internal components
can cause fire or shock, and may void your
guarantee.
If water or small objects enter the unit,
unplug the power cord immediately and
consult an authorized Harman Kardon
service center. Using the unit under such
conditions may cause a fire or shock
hazard.
Cleaning
Remove dust by wiping the unit with a soft,
dry cloth. If necessary, use a soft cloth
lightly dampened with mild soapy water;
then wipe with a dry cloth. Never use
benzine, thinner, alcohol or other volatile
agents, and avoid spraying insecticides
near the unit.
The appliance conforms with EEC
directive 87/308/EEC regarding inter-
ference suppression