Harman Kardon TD4400 - Page 7

Inserting a Tape
1.
2.
3.
Check cassette tape for excessive
slack. If necessary, insert a pencil
into one of the cassette hubs and
rotate to take up slack.
Press Eject.
Insert cassette, tape side down, and
close compartment door.
NOTE: The cassette deck determines the
type of tape in use and sets Bias/
Equalization circuitry automatically.
Play’
1.
2.
ing a Tape
If tape was recorded with Dolby Noise
Reduction, press Dolby NR button.
OM and “B” or “C” will appear on the
display panel. Choose B or C by
pressing the B/C button.
Press > to begin play.
Previewing a Tape (TD4400 only)
Press Intro Scan. Cassette deck
locates the beginning of recorded
material and plays for 15 seconds.
Tape is then advanced to the
beginning of each successive
tecorded segment, or track, playing
for 15 seconds before automatically
advancing to the next track.
To stop Intro Scan, press & (Stop).
Or, press P during any 15-second
play segment, and tape will continue
to play.
Locating Places on a Tape
(TD4400 only.) To move quickly to
the beginning of any desired
selection, use the Skip reverse and
Skip Forward buttons (Kd and PPI
at upper right corner of the deck).
a. Pressing ¢<¢ rewinds the tape to
the beginning of the current
selection. “P 00” is displayed to
indicate this selection.
OPERATING INSTRUCTIONS
b . To locate the beginning of a
previous selection, repeat pressing
kK. Display shows “P-01," “P-
02,” “P-03,” etc., to indicate first,
second, third selection previous to
the original selection.
c. To locate the beginning of the
selection following the original
selection, press PP. “P01” is
displayed. Continue pressing PP!
to locate subsequent selections
(designated "P 02,” “P 03,” etc.).
Use the Counter. The Linear Time
Counter indicates approximate tape
position in minutes and seconds.
Press Counter Reset at the start of a
cassette and/or to identify any desired
point on the tape. (Elapsed time is
maintained in Fast Forward and
Rewind.) When counter is reset to
00:00 at the beginning of a cassette,
the approximate time remaining can
be determined by subtracting the
counter reading from the total tape
time. The Linear Timer Counter
accuracy is typically within 1 minute of
the tape's actual running time.
Recording a Tape
A: Turn Bias Fine Trim knob to middle
position or to previously determined
proper position for this tape (refer to
following section for details).
Press the Dolby NR button to turn
Dolby circuitry on/off, and press B/C
button to select Dolby B or C as
follows:
a. To record a tape without Dolby
Noise Reduction, turn the Dolby
NR switch off.
b. To record a tape with Dolby Noise
Reduction, turn the Dolby switch
on, and select Dolby B or C with
the B/C switch.
ce. When recording with Dolby Noise
Reduction, consider the equipment
on which you will play your tape. If
playback equipment is not
equipped for Dolby, turn the Dolby
switch Off. If itis equipped for
Dolby, turn the Dolby switch On;
then select B if playback device is
equipped only for Dolby B;
otherwise select C.