OPERATION 9
Preset Setting
Besides having the TU 980 create a station list,
you can also store presents into the tuners
memory.
1. Tune to the desired station with the Control
Ring
9
.
2. Press the Memory Button on the front
panel
8
or on the remote control
9
. You
will see the 01 segments in the Information
Display
6
will start to blink.
3. Turn the Control Ring, until the desired
station preset is shown in the Information
Display. The desired preset can also be entered
with the Numeric Keys on the remote
control
1
.
4. Within 4 seconds, press the Memory Button
again to store the station in the memory.
Information settings
The DAB signal contains besides the radio
station additional information. This information
can be made visible in the lower display line of
the Information Display
6
.
The following information is available to display:
1. Dynamic Label Segment (DLS): scrolling text,
supplied by the broadcaster.
2. Program Type: describes the type of broad-
cast, e.g. Pop Music or Drama.
3. Multiplex Name: will show the name of the
multiplex of the broadcaster.
4. Time and Date.
5. Bitrate: shows the bitrate of the incoming
digital signal.
6. Channel and Frequency.
7. Signal Error Rate:
In this section you can see the level of correc-
tion the TU 980 is applying to the DAB signal
to maintain the audio quality. The level will be
indicated by a numeric value between 0 (no
correction) and 99 (maximum correction). For
an acceptable quality, the value of 50 should
not be exceeded.
8. Software Version: will show the actual soft-
ware version of the product.
To change between the options, press the Info
Button on the front panel
4
or on the remote
control
3
. Note that the upper display line will
always show the actual station. Pressing the
Info Button again will show the next option.
When you have found the information you
would like to display, press the Select
Button
A
8
to activate the change.
Function Control
The DAB mode in the TU 980 contains a menu
structure to access various system options. To
enter the menu, press the Function Button on
the front panel
3
or on the remote control
6
once. To scroll through the list of sections of the
menu, turn the Control Ring
9
or press the
Scroll Buttons on the remote control
5
. The
sections will be shown on the lower display line
in the Information Display. To enter a section
and see the options, press the Select Button
Select button
A
8
. You can scroll through
the options with the Control Ring and activate
an option by pressing the Select Button once
that option is shown on the Information
Display.
Station Order
In this section you can select the way the station
list is displayed. The options are Alphanumeric
and Ensemble Station.
The Alphanumeric option is the default setting.
It will list the stations in numeric and
alphabetical order.
The Ensemble Station option will list the avail-
able stations based on their frequency.
Operation
ENGLISH
To Next Page
Loading...
