Harman® • Accentra 52i Installation Manual_R2 • 2013 -___ • 07/1316 3-90-00574i
Vent Congurations:
Hearth & Home Technologies assumes no responsibility
for, nor does the warranty extend to, smoke damage
caused by reverse drafting of pellet appliances under
shut-down or power failure conditions.
Vent Pipe
Venting Termination Requirments
For Canada Only: This Fireplace Insert must be
installed with a continuous chimney liner of 4”
diameter extending from the replace insert to the top
of the chimney. The chimney liner must comform to the
Class 3 requirements of CAN/ULC-S635, Standard for
Lining Systems for Existing Masonry or Factory-Built
Chimneys and Vents, or CAN/ULC-S640, Standard for
Lining Systems for New Masonry Chimneys.
WARNING! DO NOT CONNECT THIS UNIT TO ANY AIR
DISTRIBUTION DUCT OR SYSTEM.
To Next Page
Loading...
