Harman Accentra 52i - Frequently Asked Questions

Harman® • Accentra 52i Installation Manual_R2 • 2013 -___ • 07/1324 3-90-00574i







     



Cast Side
Panel spacing
Figure 5.22
D. Reminders
Always disconnect the power cord before the unit is
pulled from the mounting frame.








Do not allow pellets or sawdust to build up on the
hopper lip.
Inspect the hopper lid gasket for damage. A good hopper
lid seal is very important for proper operation.
6 amp glass
fuse
Inspect the wiring harness transition area: Thisistheareathat
comesclosesttothemountingframeastheunitisslidinandout
oftheframe.
11 pin socket on
rear of control
board


