Harman Accentra 52i - Fuel Specifications and Storage

Harman® • Accentra 52i Installation Manual_R2 • 2013 -___ • 07/139 3-90-00574i
4
Termination Location and Vent Information
A. Venting Termination Design
#1 Installing into an existing replace chimney





CHIMNEY CONNECTOR PIPE MAY NOT PASS
THROUGH CONCEALED SPACES INCLUDING AN
ATTIC, ROOF SPACE, CLOSET, FLOOR OR CEILING.

#2 Installing into an existing replace chimney

          







     
   
 

    
      
   
    
   

   
    




    
      
   
    
   

   
    

Figure 4.1
Figure 4.2
DO NOT REMOVE BRICKS OR MORTAR FROM THE
EXISTING FIREPLACE.
DO NOT REMOVE BRICKS OR MORTAR FROM THE
EXISTING FIREPLACE.
WARNING
!
WARNING
!
WARNING
!