Do you have a question about the Harman Crown CDi 6000 and is the answer not in the manual?
Essential safety guidelines for amplifier operation and installation, covering 18 key points.
Critical warnings about preventing electrical shock, including 'Do Not Open' notices.
Information on Class 2 output wiring and magnetic field considerations.
Typical input and output wiring connections for dual-channel amplifier operation.
Diagram and instructions for connecting speakers and setting up bridge-mono mode.
Methods to prevent amplifier clipping and subsonic signals to protect speakers.
Step-by-step guide for powering on the amplifier for the first time.
Essential precautions for safe and optimal amplifier operation, including warnings.
How to change DSP settings like crossovers, EQ, delay, and limiting via the front panel.
Step-by-step button press sequences to access and configure DSP functions and presets.
Diagnosing amplifier problems based on LED indicators and lack of power.
Identifying causes of distorted audio output, such as high input levels.
Resolving 'no sound' issues related to fault mode, shorted loads, and cooling.
Addressing 'no sound' issues from turn-on delay, thermal protection, low signal, or speaker connection.
Technical specifications for power output ratings and frequency response.
Guidelines for amplifier maintenance, safety precautions during service, and obtaining support.
Procedures for obtaining service and repair, including factory service.
Details of the warranty coverage, period, and specific exclusions for US and Canada.
Essential safety guidelines for amplifier operation and installation, covering 18 key points.
Critical warnings about preventing electrical shock, including 'Do Not Open' notices.
Information on Class 2 output wiring and magnetic field considerations.
Typical input and output wiring connections for dual-channel amplifier operation.
Diagram and instructions for connecting speakers and setting up bridge-mono mode.
Methods to prevent amplifier clipping and subsonic signals to protect speakers.
Step-by-step guide for powering on the amplifier for the first time.
Essential precautions for safe and optimal amplifier operation, including warnings.
How to change DSP settings like crossovers, EQ, delay, and limiting via the front panel.
Step-by-step button press sequences to access and configure DSP functions and presets.
Diagnosing amplifier problems based on LED indicators and lack of power.
Identifying causes of distorted audio output, such as high input levels.
Resolving 'no sound' issues related to fault mode, shorted loads, and cooling.
Addressing 'no sound' issues from turn-on delay, thermal protection, low signal, or speaker connection.
Technical specifications for power output ratings and frequency response.
Guidelines for amplifier maintenance, safety precautions during service, and obtaining support.
Procedures for obtaining service and repair, including factory service.
Details of the warranty coverage, period, and specific exclusions for US and Canada.
| Channels | 2 |
|---|---|
| Signal to Noise Ratio | > 100 dB |
| THD | < 0.5% |
| Input Sensitivity | 1.4V |
| Gain | 32 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | < 0.5% |
| Input Impedance | 20 kOhms |
| Dimensions | 19 x 3.5 x 15.75 inches |
| Power Requirements | 100V-240V ~50/60Hz |
| Damping Factor | > 500 from 20 Hz to 1 kHz |












Loading...