Receive Key Accepted (56h)
SYS_HEAD, 56(h), cc1, cc2, F7(h)
cc Code echoed for the Key Scan received. (00(h) if key is invalid)
The Receive Key Accepted procedure is sent from the DDP in response and acceptance of a Receive Scan Code
Key or Receive Hold Scan Code Key procedure but is ignored if received by the DDP.
Reset Program (20h)
SYS_HEAD, 20(h), F7(h)
The Reset Program procedure causes the DDP to reload the current saved program.
Reset Device (21h)
SYS_HEAD, 21(h), F7(h)
The Reset Device procedure causes the DDP to reboot the software as if the power had been turned off, and then
back on. If edits have been made to the current program without saving, they will be lost.
,,,,,yyyyyzzzz{{{{{||||
To Next Page
Loading...