Figure 7.
- Use this method when
connecting two subwoofers to
satellites.
If you are using two subwoofers as a
stereo pair with a pair of satellites, connect
them as shown in Figure 7.
The subwoofer has a variable frequency
control that can be used to block unwanted
frequencies (between 50 - 150Hz) from
being reproduced by the subwoofer.
When you set this control depends on the
low-frequency capabilities of your satellite
speakers. Adjust this knob to the lowest
frequency that you satellite speakers were
designed to reproduce (refer to Operation,
step 7).
9
Amplifier/Subwoofer BU-80/HTS-10
To Next Page
Loading...
Need help?
General