Harman JBL Stage 2 Series - In-Wall Specifications

Stage 2 Architectural Loudspeakers Installation Guide | ©2022 Harman International Pg 6
Specications
In-Walls
Stage 250WL Stage 260W Stage 280W
High Frequency Transducer
1" (25mm) Aluminum dome
withHigh-DenitionImaging
(HDI™) horn
1" (25mm) Aluminum dome
withHigh-DenitionImaging
(HDI™) horn
1" (25mm) Aluminum dome
withHigh-DenitionImaging
(HDI™) horn
Low Frequency Transducer
Dual 5.25" (130mm)
Polycellulose cone woofer
6.5" (165mm) Polycellulose
cone woofer
8" (200mm) Polycellulose
cone woofer
Recommended Amplier
Power
20-120W RMS 20-100W RMS 20-120W RMS
Frequency Response
52Hz-25kHz (-6dB on-axis) 50Hz-25kHz (-6dB on-axis) 42Hz-25kHz (-6dB on-axis)
Sensitivity (2.83V@1m)
90dB 87dB 90dB
Nominal Impedance
8ohm 8ohm 8ohm
Crossover Frequency
2100Hz 1900Hz 1700Hz
Inputs
Nickel-plated spring-loaded
connectors
Nickel-plated spring-loaded
connectors
Nickel-plated spring-loaded
connectors
Grille Dimensions
H: 19.5in (496mm) x W 7.6in
(194mm)
H: 13.3in (339mm) x W 8.5in
(217mm)
H: 15.7in (400mm) x W 10.5in
(266mm)
Cutout Dimensions
H: 18.1in (460mm) x W: 6.4in
(162mm)
H: 12.2in (311mm) x W: 7.2in
(184mm)
H: 14.6in (372mm) x W: 9.4in
(238mm)
Mounting Depth
3.8in (96mm) 3.6in (92mm) 3.9in (98mm)