Harman P35I - 1. Feed Motor; 2. Combustion Blower; 3. ESP- (Exhaust Sensing Probe)

35
Save These Instructions 3-90-775R36_09/15
2. Combustion Blower
Requires no lubrication.
Keep the motor windings free of dust. Can be wiped clean
or vacuumed.
To remove combustion blower:
• Slide the insert body out of the mounting frame.
• Locatethecombustion blower motorintheback right
corner.
• Loosen 3 wing screws and turn the blower and mounting
plate1/4turn.
• Lower the motor and paddle fan out of the blower
housing.
3. ESP- (Exhaust Sensing Probe)
Remove and wipe clean with a soft cloth and glass cleaner
or alcohol.
To remove the probe:
• Slide the insert body out of the mounting frame.
• The probe is installed on the side of the exhaust
chamber.
• With a 1/4" socket or driver, remove the screw that
attaches the probe.
• Pull the probe out of it's mounting hole.
1. Feed Motor
Requires no lubrication.
Keep the motor windings free of dust. Can be wiped clean
or vacuumed.
To remove feed motor:
• Slide the insert body out of the mounting frame.
• Between the feed motor and the feeder body, you'll see
thecamblockwithabearingthatactuatesthepusher
arm.
• With a 7/16" wrench, loosen the hex-head bolt in the
end of the cam.
• Withtheboltloosened,thefeedmotoranditsmounting
bracketwillpullstraightoutoftheaugershaft.
Loosen bolt in
endofcamblock
ESP
Location