Harman P42i-TC - Prompts, Messages, and Errors; System Prompts and Messages; Error Code Troubleshooting

Harman® • P42i Owner’s Manual • 2023 -___ • 03/2310 8742-900A
L. Cleaning Prompts, Messages and Errors
YourEASYTouchControlcommunicateswithyoubyshowingmessagesonthetopcenteroftheEASYTouchControlhome
screen.Ifyouhavemorethanonemessage,themessageswillshowconsecutivelyuntilyouacknowledgethemessageby
performing the task. These communications include:
PROMPTS
MESSAGES
ERRORS
Clean your stove. Call your Harman Dealer if problem
persists.
When prompted, scrape burnpot. Press checkmark to reset.
When prompted, inspect and empty ash pan as needed.
Press checkmark to reset.
When prompted, inspect and perform total clean. Press
checkmark to reset.
Presscheckmarkifyoulledthehopper.Ifyoudidnotll
hopper,Themessagewilldisappearin30seconds.
Replacethe2“AA”batteriesintheWirelessRemoteSensor.
If Wireless Remote Sensor batteries die, the Back Up
Sensorwillcontinuetoheatyourhome.
Check and close the front and ash doors for the stove to
continue to heat.
Close the hopper lid for the stove to continue to heat.
Fill the hopper with pellets. Press checkmark to reset. If
youdidnotllthehopper, the message will stop after30
seconds.Thiserroronlyappearsif“ShowFuelGauges”is
turned on.
BatteriesinWirelessRemoteSensorhaveexpired.Replace
the 2 “AA” batteries.
ReturnAirSensorhasfailed.CallyourHarmanDealer.
Unit has failed to ignite. Scrape the burnpot. Call your
Harman Dealer if problem persists.
Touch Control has lost communication to the stove. Call
your Harman Dealer.
ExhaustSensingProbe(ESP)asfailed.CleantheESP.If
issue persists, call your Harman Dealer.