Harman P42i-TC - Product Specifications and Safety Information; Appliance Certification and Approvals; Technical Specifications and Fuel

Harman® • P42i Owner’s Manual • 2023 -___ • 03/234 8742-900A
1 1
Product Specic and Important Safety Information
A. Appliance Certication
NOTE: Thisinstallationmustconformtolocalcodes.Inthe
absence of local codes you must comply with the ASTM
E1509,ULC-S628 & (UM) 84-HUD
THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, WALL, AND CEILING/
ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
The P42i-TC Pellet Insert is certied to
comply with 2020 EPA particulate emission
standards.
MODEL: P42i-TCPelletInsert
LABORATORY: PFS•TECO
REPORT NO. F22-858
TYPE: PelletFueledInsert/Supplementary
ForResidentialUse
STANDARD(s): ASTME2779,ASTME2515,ASTM
E1509,ULC-S628
ELECTRICAL
RATING:
120VAC,60Hz,Start4.2Amps,Run
2.8 Amps
GLASS
SPECIFICATION:
5mmmirroredceramicglass
B. Manufactured Home Approved
This appliance is approved for manufactured home
installations when not installed in a sleeping room and when
an outside combustion air inlet is provided.
The structuralintegrity of the manufactured home oor,
ceiling, and walls must be maintained. The appliance must
be properly grounded to the frame of the manufactured home
anduseonlylistedpelletvent,Class“PL”connectorpipe.
AHarman®OutsideAirKitmustbeinstalledinamanufactured
home installation.
WARNING
Risk of Fire! Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will
be voided by the below actions.
C. BTU & E󰀩ciency Specications
EPA Certication Number: F22-858
EPA Certied Emissions: 1.0 g/hr
*LHV Tested E󰀩ciency: 84%
**HHV Tested E󰀩ciency: 79%
***EPA BTU Output: 5,637-32,782
****BTU Input 7,400 – 41,800
Vent Size: 4Inch
Hopper Capacity: 64.5lbs
Fuel Wood Pellet
NOTE: Hearth & HomeTechnologies, manufacturer of
this appliance, reserves the right to alter its products, their
specicationsand/orpricewithoutnotice.
* Weighted average LHV eciency using data collected
during EPA emissions test.
**Weighted average HHV eciency using data collected
during EPA emissions test.
***A range of BTU outputs based on EPA Default Eciency
and the burn rates from the low and high EPA tests.
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
Thiswoodheaterhasamanufacturer-setminimumlowburn
ratethatmustnotbealtered.Itisagainstfederalregulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
properoperation.Itisagainstfederalregulationstooperate
this wood heater in a manner inconsistent with operating
instructions in this manual.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overre
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualied
installer, service agency or your dealer.
Harman
®
 is a registered trademark of Hearth & Home
Technologies.
This wood heater needs periodic inspection and repair for
properoperation.Itisagainstfederalregulationstooperate
this wood heater in a manner inconsistent with operating
instructions in this manual.
CAUTION