Harman® • P42i Owner’s Manual • 2023 -___ • 03/2316 8742-900A
Caring for your Glass-
The glass used in your stove is manufactured to exact
standardstowithstandthehighheatofthere,butlikeall
glass, it must be treated with common sense and care. Never
abuse the glass by slamming the door shut or striking the
glasswithaheavyobject.Iftheglassisbrokenordamaged,
do not operate the stove until it has been replaced.
Glass - Replacement:
Ifthestove’sglassiscrackedorbroken,youmustreplace
it before operating your stove. Remove pieces carefully.
Replace glass only with Harman® replacement glass; do
not use substitutes.
Carefully remove damaged glass, gasket material, and glass
clips (set aside).
Installtheselfadhesive1/4”gasketmaterialaroundthefront
faceoftheglass.Settheglasspanelandgasketgentlyonto
thedoor.Installtheglassclipsand1/4-20X1/2”screws.
Note:1/4-20X1/2”screwsonlyneedtobesnugt.Donot
overtighten.
Glass - Cleaning:
Sometimesitwill benecessarytocleanaccumulated ash
fromtheglasssurface;allowingthisashtoremainonthe
glass for long periods can result in “etching” due to the acidity
of the ash. Never clean the glass while it is hot, and do not
use abrasive substances. Wash the surface with cool water
andrinsethoroughly.Youmaywishtouseanon-abrasive
cleanerspecicallydesignedforuseonstoveglass.Inany
case, dry thoroughly before relighting your stove.
Glass Gasket
Replace glass only with high
temperature ceramic glass.
Inspect door gasket during
cleaning and inspection
(4) Glass Clips
(4)1/4-20X1/2”
ButtonHeadScrew
Figure 2.14
Figure 2.15
Inspect hopper lid gasket
during cleaning and inspection
Inspect all Gaskets-
While the unit is cool, inspect all door gaskets to ensure
proper seal. The gasket should be continuous without frays
ortears;havingplyablegasketmeanshavingacorrectseal
forproperoperation.Figures2.14&2.15.
Distribution Blower-
Checking the distribution blowers yearly is a good habit to
get into. Dust, animal hair or anything else that can make
its way into that area can drastically cut down on the air
movement throughout the unit ultimately causing less of a
heatingeciency.
Oncetheunitisshutdownandcooled,unplugtheunitfrom
its power supply. Behind each side panel release (1) spring
latches that holds the unit to the inserts cage. Figure 2.16.
Figure 2.16
Openspringlatch