Harman P61A - Page 15

15
P 6 1 A P ellet S tove
3 -9 0 -0 5 8 2 2 R 2 8 _ 0 8 /1 3
AUTOMATIC IG NITION/ OPER ATION
The P1A is a fully automatic stove that features two
operating modes Stove Temperature Mode and R oom
Temperature Mode. In Stove Temperature ode, you select
a burn rate and the stove will remain at the same burn rate
regardless of the room temperature.
In the Room Temperature ode the stove constantly monitors
the temperature in the room and adusts the size of the re
and the heat output of the stove so that the room is kept at
a constant temperature. Room mode, in the AUTO position,
has the added advantage of turning the stove off if no heat
is required and turning the stove on again when the room
temperature drops below your desired room temperature.
R oom Temperature Mode
ost consumers use the stove in the Room Temperature
ode because it is the easiest and most efcient method
of keeping the room at a given temperature. In the Room
Temperature ode, the Room Sensing Probe constantly
monitors room temperature. As the weather changes outside
and your home needs varying amounts of heat to be at a
desired temperature, the stove will automatically increase re
size and heat output so that a constant even temperature is
maintained. If the weather warms up and no heat is required,
the stove will gradually shut down. When the house cools
down, the stove will automatically bring the room temperature
to the precise temperature you desire.
In the Room Temperature ode you can select either Auto
or Manual modes for the igniter, using the igniter toggle
switch. When the toggle switch is in the Auto position, the
igniter, located inside the burn pot, is ready to automatically
light the re when required. When the toggle switch set to the
anual position the stove can be lit manually with either a gel
or a wax type re starter. (see lighting instructions on page
1.) With the igniter toggle switch set in the anual position
the stove will automatically adust heat output, but the stove
will not automatically shut down if no heat is required. Instead
it will go to its lowest setting and remain there. The anual
position on the igniter toggle switch lets you light the stove
manually, should the igniter fail for any reason. Secondly if
you are using the Harman battery back up system, the anual
setting will prevent the stove from turning off and on during
a power failure, which would drain the back up battery, and
possibly cause damage to the back-up or the stove.
In the Room Temperature ode, the distribution blower speed
can be increased or decreased by adusting the Room Temp
OffStove Temp dial between L and H. As output of the stove
increases, the speed of the blower will increase automatically
to insure that more heat is transferred out into the room. The
distribution blower will shut off as the room reaches the set
temperature, this will prevent overheating of the room.
R oom Temperature Mode: This setting, see above, will produce
a room temperature of 70 degrees with the distribution blower at
medium speed.
R oom Temperature Mode
CAUTION:
O NOT CONNECT TO ANY AIR ISTRIBUTION UCT
OR SYSTE.
O NOT BURN GARBAGE OR LAABLE LUIS
SUCH AS GASOLINE, NAPTHA, OR ENGINE OIL.
HOT WHILE IN OPERATION. EEP CHILREN,
CLOTHING, AN URNITURE AWAY. CONTACT AY
CAUSE SIN BURNS.
EEP IREBO AN ASH REOAL OORS CLOSE
URING OPERATION. AINTAIN SEALS IN GOO
CONITION.