Harman P61A - Aintenance

21
P 6 1 A P ellet S tove
3 -9 0 -0 5 8 2 2 R 2 8 _ 0 8 /1 3
Maintenance
nmn rete
Whenever wood is burned slowly, the potential exists for creosote to form in the venting. The chimney or venting system
should be inspected periodically throughout the heating season to determine if a creosote buildup has occurred. If a signicant
layer of creosote has accumulated (mm or more), it should be removed to reduce the risk of a chimney re. A professional
chimney sweep is recommended, since they would normally have the correct equipment to ensure proper creosote removal.
 yu eperence a re n te entn ytem turn the stove to O to allow the unit to shut down. Call the re department,
and be sure everyone is out of the residence. Before re-using the appliance, have it, and the venting system thoroughly
inspected and replace any damaged components.
The glass in your Harman stove is a special 5mm
ceramic glass.
• o not abuse the glass by striking or slamming
the door.
• Never burn the appliance if the door glass is
cracked or broken.
• Replace only with Harman supplied glass. o
NOT Use Substitutes.
Soot andor y-ash may accumulate on the viewing
glass, and will ocassionally need to be cleaned. Clean
the glass with a soft cloth and mild glass cleaner. o
not clean the glass when hot, and avoid the use of
abrasive cleaners.
Glass replacement
Carefully remove all remaining glass and gasket
materials prior to replacing the glass.
Lay the door face down on a at surface. Remove the
glass retainers and screws. Apply the gasket material
to the face of the new glass. Lay the glass into the
door, making sure that the glass is contained within
the channels and raised areas of the door itself. Lay
the glass retainers into position and install the screws. Tighten each screw evenly to avoid making any stress points.
Retainers and screws
Glass
Adhesive gasket
oor rame
W AR NING
INSPECT APPLIANCE AND COMPONENTS
F OR DAMAG E. DAMAG ED PAR TS MAY
IMPAIR SAF E OPER ATION.
 DO NOT INSTALL DAMAG ED
COMPONENTS.
 DO NOT INSTALL INCOMPLETE
COMPONENTS.
 DO NOT INSTALL SUBSTITUTE
COMPONENTS.
R EPOR T DAMAG ED PAR TS TO DEALER .
F IR E R ISK .
HEAR TH & HOME TECHNOLOG IES
DISCLAIMS ANY R ESPONSIBILITY
F OR , AND THE W AR R ANTY W ILL
BE V OIDED BY , THE F OLLOW ING
ACTIONS:
 INSTALLATION AND USE OF ANY DAMAG ED
APPLIANCE.
 MODIF ICATION OF THE APPLIANCE.
 INSTALLATION OTHER THAN AS INSTR UCTED BY
HEAR TH & HOME TECHNOLOG IES.
 INSTALLATION OF PAR TS OR COMPONENTS NOT
SUPPLIED OR APPR OV ED BY HEAR TH & HOME
TECHNOLOG IES.
 OPER ATING APPLIANCE W ITHOUT F ULLY
ASSEMBLING ALL COMPONENTS.
OR ANY SUCH ACTION THAT MAY CAUSE A F IR E
HAZ AR D.
W AR NING