Harman XXV - Installation & Clearances; Mobile Home Installation

4
XXV Pellet Stove
CAUTION
HOT WHILE IN OPERATION. KEEP
CHILDREN, CLOTHING AND FURNITURE
AWAY. CONTACT MAY CUASE SKIN
BURNS.
DO NOT INSTALL A FLUE DAMPER IN THE
EXHAUST VENTING SYSTEM OF THIS UNIT.
DO NOT CONNECT THIS UNIT TO A CHIMNEY
FLUE SERVING ANOTHER APPLIANCE.
CAUTION
KEEP COMBUSTIBLE MATERIALS (SUCH
AS GRASS, LEAVES, ETC.) AT LEAST 3
FEET AWAY FROM THE FLUE OUTLET
ON THE OUTSIDE OF THE BUILDING.
IMPORTANT NOTES
Flame Guide
Install the cast iron ame guide on top of the burn
pot.Makesurethattheameguideisfullyseatedon
the vertical sides of the burn pot and that the back of
the guide rests against
the burn pot mounting
ange.
Install the exhaust
/ v e nt in g at t he
clearances specified
b y t h e v e n t i n g
manufacturer. Some
brands of pellet venting
require a 3" clearance
to combustibles, while
other brands require
only one inch.
Figure 1
The power cord is tucked inside the left rear cover
panel. To remove cord, Loosen the two 5/16" hex
heads and slide the panel outward.
Assembly and Installation
Due to high temperatures, the stove should be
placedoutoftrafcand awayfromfurnitureand
draperies.
Children and adults should be alerted to the haz-
ards of high surface temperatures and should stay
away to avoid burns to skin and/or clothing.
Young children should be carefully supervised
when they are in the same room as the stove.
Clothingandotherammablematerialsshould
not be placed on or near this unit.
Installation and repair of this Harman stove
shouldbedonebyaqualiedserviceperson.We
recommend that the stove be inspected before use
andatleastannuallybyaqualiedserviceperson.
Periodic cleaning is required throughout the heat-
ing season and at the end of each winter for the
stovetoworkefciently.Seecleaninginstructions
on page 22.