8
CERTIFICATIONS
! The child restraint shall not be used without the cover.
It MUST always be used with the fabric cover provided
by the manufacturer.
! The seat cover should not be replaced with any other
than the one recommended by the manufacturer,
because the cover constutes an integral part of the
restraint performance.
! PARTS OF THE CHILD RESTRAINT COULD BECOME
HOT ENOUGH TO BURN THE CHILD IF LEFT IN THE
SUN. Contact with these parts can injure your child.
ALWAYS touch the surface of any metal or plasc parts
before pung your child in the child restraint. Cover
the child restraint with a towel or blanket when the
vehicle is parked in direct sunlight. KEEP AWAY FROM
SUNLIGHT, OTHERWISE IT MAY BE TOO HOT FOR
THE CHILD’S SKIN.
This is a “Universal” child restraint when installed using
the 3-point vehicle seat belt only. It is approved to the
! Use ONLY the vehicle’s 3-point lap-and-shoulder belt
system when restraining a child in this child restraint.
DO NOT use this child restraint with 2-point vehicle
belts (lap-belt only or shoulder-belt only). Your child
would be seriously injured in the event of a crash.
! DO NOT use this child restraint with unsafe vehicle
seat belts listed in secon “Unsafe vehicle seat belt
systems” of this manual.
! DO NOT use this child restraint if it can’t be properly
installed. It is possible that your vehicle has no suitable
seang posion for this child restraint due to seat belt
type, airbag system and/or lack of locaon of a tether
strap anchor. Read and follow these instrucons, and
your vehicle owner’s manual carefully.
VEHICLE WARNINGS
To Next Page
Loading...
