DOUBLE LOOP CONTROL
15 of 17
When auto-tuning is complete, turn off the heater
switch and allow the accessory to cool to room
temperature. When the accessory is cool, the
upper display should read between 18 and 26
degrees C.
OPERATION
With the system auto-tuned to the desired set point
temperature:
• Make sure the accessory is at room temperature.
The upper display should read between 18 and 26
degrees C.
• When the accessory is ready to be heated, turn on
the heater switch. The accessory will now heat to
the set point temperature and hold that
temperature.
To Next Page
Loading...