THE TEMPERATURE CONTROLLER
4 of 17
CONNECTING THE ATC
To connect the temperature controller to the accessory:
• Check to make sure that all the switches on the
temperature controller are off (Figure 1).
• Plug in the AC line cord into the unit and into a
suitable AC outlet (Figure 2).
• If your accessory has only one thermocouple,
connect the thermocouple to the connector
labeled TC1 on the back of the temperature
controller.
• If your accessory has two thermocouples,
connect the heater thermocouple to the
connector labeled TC2 on the back of the
temperature controller and the sample
thermocouple to TC1.
• Connect the heater to the heater connector
located on the front of the temperature controller.
To Next Page
Loading...