To Next PageTo Next Page
Need help?Do you have a question about the Harris 156593 and is the answer not in the manual?
General| Brand | Harris |
|---|---|
| Model | 156593 |
| Category | Water Filtration Systems |
| Language | English |
Essential guidelines for safe operation and installation of the sand filter system.
Explains how water is pumped through the filter sand to trap dirt and debris for effective filtration.
Place the filter on a level surface ensuring convenient access for operation and servicing.
Mount the filter tank, check laterals for damage, and ensure proper alignment and seating.
Attach the top mount valve using the O-Ring and flange clamp, ensuring stem pipe alignment.
Set valve to BACKWASH, start pump to fill tank, and run for one minute to flush impurities.
Switch to RINSE to clear water, then to FILTER for normal operation, monitoring pressure gauge.
Directs water through the filter bed to trap dirt and debris for clean pool water.
Reverses water flow to flush trapped dirt and debris from the filter bed out the waste line.
Settles filter media and flushes residual dirt after backwashing, preventing return to the pool.
Backwash when flow decreases, efficiency drops, or pressure rises 7.2 PSI above start-up.
Steps to turn off the pump, set valve to BACKWASH, run until clear, then switch to RINSE.
Perform backwashing regularly as per the BACKWASHING instructions to maintain filter efficiency.
Maintain proper pH, Total Alkalinity, and Calcium Hardness for optimal filter media life.
Lists causes for dirty water including insufficient filtration, heavy loads, or air leaks.
Covers issues like excessive media, incorrect flow, or media returning to the pool due to damage.
Provides item numbers, flow rate, maximum pressure, filter area, and media requirements.
