4-12
RF-7800B
CONFIGURATION
d. If the Service Provider requires a username and password, enter it in the Username and Password boxes,
then click Apply.
e. The new connection appears in the Network Connections table. Once the context has been setup,
whether it is successful or not, the properties will remain in the table above. In the table above, the entry
can be cleared by clicking the associated Clear button.
There are two buttons to the right of each CID definition in the table. When a context is defined but
inactive, the Activate button is available to try and start the connection. If the connection is active, the
button changes to Deactivate to break the connection. The Clear button is used to delete an Inactive
connection and make the CID available for reuse.
Figure 4-7. BGAN Terminal Network Connections
To Next Page
Loading...