Harris RF-7800B-DUO24 - BGAN Terminal Antenna Status

4-19
RF-7800B
CONFIGURATION
R
Built-in Test Results: Provides values for the built-in tests performed at startup. A displayed value of Pass means
No Fault. A displayed value of 255 means test result not available. A displayed value other than Pass or 255 indicates
a possible failure. Refer to Table 4-3 for Antenna Built-In Test (ABIT) results. For faults, refer to Paragraph 5.2.1.
For any recurring faults, return unit for repair.
Visible Satellites: Information on the nearest satellite as well as the primary and secondary satellites is displayed.
Where two satellite regions overlap, information on the nearer of the two satellites will be displayed.
Figure 4-11. BGAN Terminal Antenna Status
Table 4-1. Antenna Status ATB State
State Name State Description
Initial Initial state
Idle Wait on a frequency from the BGAN terminal.
Seek 1 Determine minimum/maximum signal levels in a full sky scan.
Seek 2 Find azimuth direction.
Seek Elevation Determine minimum/maximum signal levels on a single elevation.
Track and Tune Track and tune elevation state.
Track and Tune PLL Track and tune Phased Lock Loop (PLL) state.