HART HGCS02 20V User Manual

16 – English
SeetheAdjusting the Chain Tension instruc-
tionsintheMaintenancesectionofthismanual
toproperlyadjustthechaintension.
STARTING/STOPPING THE CHAIN SAW
See Figure 7.
WARNING:
Keepbodytotheleftofthechainline.Never
straddlethesaworchain,orleanoverpastthe
chainline.Improperoperationofthechainsaw
couldresultinseriouspersonalinjury.
Starting the chain saw:
Placethechainsawonaflatbaresurfaceand
makesurenoobjectsorobstructionsareinim-
mediatevicinitywhichcouldcomeincontact
withthebarandchain.
Pressandholdthelock-outbutton.Thismakes
theswitchtriggeroperational.
Pressandholdtheswitchtrigger,releasethe
lock-outbutton and continue to squeeze the
switchtriggerforcontinuedoperation.
Stopping the chain saw:
Releasetheswitchtriggertostopthechainsaw.
Uponreleaseoftheswitchtrigger,thelock-out
buttonwill be automatically resettothe lock
position.
Thiscordlesschainsawisnotdesignedforcutting
treeslargerthan7in.indiameter.
Thiscordlesschainsawisdesignedforlimbing
andpruningtypecutting,aswellascuttingtrees
upto7in.indiameteronly.
PREPARATION FOR CUTTING
PROPER GRIP ON HANDLES
See Figures 8 - 10.
Refer to Important Safety Instructions earlierinthis
manualforappropriatesafetyequipment.
Wear non-slip gloves for maximum grip and
protection.
Holdthesawfirmlywith bothhands.Always
keepyourlefthandonthefronthandleandyour
righthandontherearhandlesothatyourbody
istotheleftofthechainline.
LOCK-OUT
BUTTON
SWITCH
TRIGGER
LOCK-OUT
BUTTON
SWITCH
TRIGGER
OPERATION
WARNING:
Neverusealeft-handed(cross-handed)grip,or
anystancewhichwouldplaceyourbodyorarm
acrossthechainline.Improperoperationofthe
chainsawcouldresultinseriouspersonalinjury.
FIG. 7
FIG. 8

HART HGCS02 20V Specifications

General

Brand	HART
Model	HGCS02 20V
Category	Chainsaw
Language	English