HART HLCS01 User Manual

10 – English
FEATURES
PRODUCT SPECIFICATIONS
Motor ................................................................................................................................... 40 Volt DC
Bar Length ....................................................................................................................................14 in.
Chainoiltankcapacity .................................................................................................................. 6oz.
NOTE: This saw was designed for occasional light duty use and has some limitations as to what it can cut.
GLOSSARY OF TERMS
LOW-KICKBACK CHAIN
A chain that complies with the kickback
performancerequirementsofANSIB175.1when
testedonarepresentativesampleofchainsaws.
NORMAL CUTTING POSITION
Thosepositions assumedin performing the
bucking and felling cuts.
NOTCHING UNDERCUT
Anotchcutinatreethatdirectsthetree’sfall.
REAR HANDLE
Thesupporthandlelocatedatortowardtherear
of the saw. It normally contains the switch trigger.
This handle is for the right hand.
REDUCED KICKBACK GUIDE BAR
Aguide bar which has beendemonstrated to
reduce kickback significantly.
REPLACEMENT SAW CHAIN
A chain that complies with the kickback
performancerequirementsofANSIB175.1when
testedwithspecificchainsaws.Itmaynotmeet
theANSIperformancerequirementswhenused
with other saws.
SAW CHAIN
Aloopofchainhavingcuttingteeththatcutthe
wood,andthatisdrivenbythemotorandissup-
portedbytheguidebar.
SPRINGPOLE
Asmalltree(sapling)orlimbthatisbentortrapped
undertension.Itmay“springback”rapidlywhen
cut, causing a dangerous situation.
SWITCH TRIGGER
Adevice that whenoperated willcomplete or
interruptanelectricalpowercircuittothemotor
of the chain saw.
KNOW YOUR CHAIN SAW
See Figure 4.
Thesafeuseofthisproductrequiresanunder-
standing of the information on the tool and in this
operator’smanualaswellasaknowledgeofthe
project youare attempting. Beforeuse of this
product,familiarize yourselfwith alloperating
features and safety rules.
CHAIN TENSIONING SCREW
This feature allows user to adjust the tension of
the chain.
GUIDE BAR
Thefactory-equipped guide barhas a small
radiustipthatoffersasomewhatlowerkickback
potential.
LOCK-OUT BUTTON
Acontrolfeaturedesignedtopreventthemotor
from being accidently started.
LOW KICKBACK CHAIN
Thelowkickbackchainhelpsminimizetheforce
ofakickbackreactionbypreventingthecutters
fromdiggingintoodeeplyatthekickbackzone.
QUICK VIEW OIL INDICATOR
Semi-transparentoilreservoirthatallowsuserto
see when to add oil.
SWITCH TRIGGER
Squeezetheswitchtriggertooperatetheunitafter
switchlock-outhasbeenpushedin.Releasethe
switchtriggertostoptheunit.

HART HLCS01 Specifications

General

Brand	HART
Model	HLCS01
Category	Chainsaw
Language	English