To Next PageTo Next Page
Need help?Do you have a question about the Hartke VS Series and is the answer not in the manual?
Connect passive bass guitars to this standard 1/4" jack. High impedance input sensitivity of 20mV.
Connect active bass guitars to this 1/4" jack. High impedance input sensitivity of 60mV.
Adjusts tube-simulating preamplification. Avoid maximum settings to prevent distortion.
Adjusts compression amount (peak reduction) and ratio from 2:1 to infinity.
Ten sliders adjust 10 frequency bands by +/-15 dB for tonal shaping.
Controls the overall output volume of the amplifier.
Connects to the internal 4-ohm speaker system. External speakers require disconnecting internal ones.
Set volume to 0, pre-amps to 5, compression off, EQ bypass, contour center.
Maximize bass output, slowly increase Master Volume to desired level.
Use the ten-band graphic equalizer sliders to fine-tune tonal response.
Activate and adjust the Compression control for dynamic range management.
Connect passive bass guitars to this standard 1/4" jack. High impedance input sensitivity of 20mV.
Connect active bass guitars to this 1/4" jack. High impedance input sensitivity of 60mV.
Adjusts tube-simulating preamplification. Avoid maximum settings to prevent distortion.
Adjusts compression amount (peak reduction) and ratio from 2:1 to infinity.
Ten sliders adjust 10 frequency bands by +/-15 dB for tonal shaping.
Controls the overall output volume of the amplifier.
Connects to the internal 4-ohm speaker system. External speakers require disconnecting internal ones.
Set volume to 0, pre-amps to 5, compression off, EQ bypass, contour center.
Maximize bass output, slowly increase Master Volume to desired level.
Use the ten-band graphic equalizer sliders to fine-tune tonal response.
Activate and adjust the Compression control for dynamic range management.
General| Type | Bass Amplifier |
|---|---|
| Inputs | 1 x 1/4" Instrument Input |
| EQ Controls | Bass, Mid, Treble |
| Dimensions | Varies by model |
| Outputs | 1 x 1/4" Headphone Output, 1 x XLR Direct Output |
| Impedance | 8 Ohms |
