7.After you have attached the puck catcher and electronic umit, suitable set the table
where you want it in your Game Room. Plug the cord into a suilable 120v
household outlet and tum the motor on by tuming the switch that is built into
the cord.
Congratulations !you have mow assembled your hockey table. Please note the care
And Use instructions below to ensure many yeas of trouble free use of your game
Table.
NOTE: Place cord in nearest outlet to minimize trip hazard.
Never set objects on cord.
CARE AND USE OF YOUR TABLE
1. Apply spray furniture polish to a clean cloth and wipe down the playfield
To make the pucks slide faster on the table.
2. Youmay use spray furniture polish to clean all exterior surfaces of your game
Table.
3. Use only a suitable 120vAC household outlet.
4. This product is intended for INDOOR use only.
5. DO NOT operate the motor if the cord is damaged in any way.
6. DO NOT sit, climb or lean on the table.
7. DO NOT drag the table when moving it This will damage the legs.
8. DO NOT set drivks on table
OPERATION OF THE ELECTRONICS
1. Remove the battery cover on the electronic umit and install 4 AA batteries
(Not included) as indicated on the battey compartment.
2. Make sure all connections are tight and completely plugged into the unit.
3. Turn the power switch on the front of the electronics to the ON position.waitf for
The unit to run its test cycle.this will be complete when there is a "zero'showing
For the HOME and VISITOR score.
4. The electronics are now ready.they will register a score when you make the puck
Into the goal.the unit will show nine points for either HOME or VISITOR
Depending on who wins the game.
5. Press the RESET button to begin a new game.
6. Turn the unit off when not in use to conserve barrery power.
NOTE: Ifthe scoring unit regesters goals on the incorrectsides, reverse the plugs that
Go in the back of the electronic uni to correct this problem.
C 2006 Escalade Sports 7 For Customer Service Call 1-866-556-2758
To Next Page
Loading...