EasyManua.ls Logo

Harvia Digital KIP - Heater Operation; Immediate Start and Delayed Start; Setting the Sauna Temperature; General Operation Information

Harvia Digital KIP
8 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KIPW Heater Installation & Owners Manual
almostheaven.com
OPERATING YOUR HEATER
Note:Yourtouchpad’sdefaultsettingsarecompatiblewithyourheater.Nochanges
are necessary.
Immediate Start
Turn your breaker on. If everything is connected correctly, the buttons at the bottom of the
screen should illuminate. The bottom left button is the main power unit - press it, and you
shouldhearaloudclunkfromthepowerunit,whichisthecontactorsengaging.Ifyoudo
nothing, it will begin heating immediately; the display will show the current temperature in the
sauna, as well as the time remaining on the heat cycle.
Delayed Start
Turnthepowerbuttononthetouchpad.Press“menu”untiltheclockiconisashing.Adjustthe
preset time by pressing + or - until you get to the desired preset time. You are able to preset your
heaterin10minuteincrementsforupto12hours.Thetimeremainingbeforeyourheaterbegins
heating should appear below the brackets at the top of the touchpad.
Setting the Temperature
The temperature displayed on the screen is the temperature inside the sauna where the temperature sensor is mounted. To set
yourdesiredsaunatemperature,pressthepowerbuttononthetouchpad.Press“menuuntilthethermometericonashes.
Adjust the temperature with the + or - until your desired temperature is displayed. The sauna will heat to and hover around this
temperature.
GENERAL OPERATION INFORMATION
• YourDigitalKIPheaterisULcertied.Becauseofthis,itisrequiredtoshutoafteronehourofuse.Ifyouwishtocontinue
your sauna session, you will have to restart the heater if the heating period times out.
• Ifyourheaterisn’theating,turnoyourbreakerandtrypressingtheresetbuttonundertheheaterasthehigh-limitsafety
circuit may have been tripped. If this continues to happen, your sensor may be too high or too close to the heater.
• Thisisatraditionalsaunaheaterwithsaunastones.Assuch,youmaypourwaterontothestonesaccordingtoyour
humidity level preference. Please note, however, it often only takes a ladle-full to achieve the desired eect.
If there is an error code displayed on the touchpad, please refer to the error code list found in the manufacturers manual
12-2022

Related product manuals