To load the cut film holder place the trimmed sheet of film below the film
frame (left), fold down the latter and push in the sheath (right). This must be
done in total darkness.
Push the cut film holder into the adaptor from the side (left), then withdraw
the sheath ready for exposure (right). After the exposure replace the sheath
before removing the film holder.
The film cutter cuts down 2½ x 3½ in. sheet films to 2½ x 2½ in. To trim the film, push
it under the cover guard so it touches the stop pins. Then trim the film with the built-in
scissor blades. This also must be done in total darkness.
FACTS AND FIGURES
This section gives the more important data for Hasselblad films, exposure, close-up data, etc., in handy tabular form for easy
reference.
Conversion of Feet and Inches to Metric Units
Many cameras are marked only in either the metric or Brisith system, while most of the tables in this book are also given in only one
system. The table below shows at a glance equivalent lengths.
To Next Page