3 / 9
again.
Step 4: Switch to the "F2" ("HY") code by press the key.
Repeat the above 2-4 steps to update all the code you
want to.
At last: Just leave the unit alone; it will auto quit from
setting mode back to normal status in 10s.
1) F1 (SET): SP (Temperature Set-Point)
2) F2 (HY): Temperature Hysteresis / Return Difference
3) F3 (US): Upper limit for SP
4) F4 (LS): Lower limit for SP
5) F5 (AC): Delay Time for the Compressor and Delay
To Next Page
Loading...
