continued from page 17
After the upper and lower limits are set, the previous
memory positions (1, 2, 3, 4) may be outside the new
range of movement. If so, simply reset the memory
positions.
If you attempt to revise a previously set upper or lower
limit and it is outside of the existing range, you will need
to remove the previously set upper/lower limits first.
HANDSET LOCK
To lock the handset:
Press and hold the “M” button (about 8 seconds) until
the LED display switches to “S -” and then to “LOC”.
Release the button.
To unlock the handset:
Press and hold the “M” button (about 8 seconds) until
the LED switches from “LOC” to the height display.
Release the button.
CHANGING INCHES TO
CENTIMETERS
Press the DOWN button on the Handset until the base
reaches its lowest position. Press and hold the DOWN
button again until the LED display reads “RST”.
Press and hold the 2 button (about 5 seconds) while
the LED flashes “RST” and then switches to either:
10.3 = cm
10.4 = inches
Release the 2 button. Press and hold the 2 button again
until the desired setting is reached. Once the chosen
setting is displayed, release the button and wait about
5 seconds for the display to return to “RST”.
Finish the reset process by pressing and holding the
DOWN button until the desk lowers a little bit more,
slightly rises and stops. Release the button. The new
measurement setting is saved and your desk is now
ready to use.
CHANGING ANTI-COLLISION
SENSITIVTY
Press the DOWN button on the Handset until the base
reaches its lowest position. Press and hold the DOWN
button again until the LED display reads “RST”.
Press and hold the UP button (about 5 seconds) while
the LED flashes “RST” and then switches to either:
10.5 = 22 lbs. (10 kg) pressure (most sensitive)
10.6 = 33 lbs. (15 kg) pressure (middle sensitive)
10.7 = 44 lbs. (20 kg) pressure (least sensitive)
Release the UP button. Press and hold the UP button
again until the desired setting is reached. Once the
chosen setting is displayed, release the button and
wait about 5 seconds for the display to return to “RST”.
Finish the reset process by pressing and holding the
DOWN button until the desk lowers a little bit more,
slightly rises and stops. Release the button. The new
anti-collision sensitivity setting is saved and your desk
is now ready to use.
TROUBLE SHOOTING
If your desk is not functioning properly it may need to
be reset. Follow the RESET procedure outlined in the
USE section.
If the LED readout displays an error message (“Er1” -
“Er13”) confirm that all wired connections are secure
(legs to cables, cables to control box). Then perform
the reset procedure outlined in the USE section.
If the error message persists after the reset
procedure, contact HAT Collective at 408 437 8770
or via email at cs@hatcollective.com
If the height between the legs exceeds 1.5 inches, stop
the reset procedure and contact HAT Collective.
If the handset displays “HOT”, let the base cool down
for 20 minutes.
PAGE 18 OF 22
To Next Page
Loading...