To Next PageTo Next PageWhat to do if my Hatco Display Case is plugged in but not working?
If your Hatco Display Case is plugged in but not functioning, first check the electrical receptacle to ensure it's working and that the power supply matches the unit's specifications. If the receptacle isn't working, check and reset the circuit breaker, or try plugging the unit into a different, known working receptacle.
Why is there too much humidity in my Hatco Display Case?
If your Hatco Display Case is heating but producing too much humidity, causing steam inside, try adjusting the humidity control to a lower setting and increasing the temperature setting.
What to do if Hatco Display Case is not producing humidity and 'LO H20' flashes?
If your Hatco Display Case is heating but not producing humidity, 'LO H20' is flashing, and the unit is full of water, and you are using distilled water, add one teaspoon of salt to the water reservoir on initial fill.
General| Model | Flav-R-Savor Series |
|---|---|
| Category | Display Case |
| Capacity | Varies by model |
| Thermostat Control | Yes |
| Type | Heated |
| Construction | Stainless steel and aluminum |
| Electrical (FS3I-1, FS3I-1X, FS3I-1W, FS3I-1XW) | 120V |
| Electrical (FS3I-2, FS3I-2X, FS3I-2W, FS3I-2XW) | 120V |
| Electrical (FS3H-1, FS3H-1X, FS3H-1W, FS3H-1XW) | 120V |
| Electrical (FS3H-2, FS3H-2X, FS3H-2W, FS3H-2XW) | 120V |
| Features | Thermostatically-controlled heat |
Complete online warranty registration to ensure prompt coverage.
Warnings and precautions regarding electrical safety and operation.
Safety guidelines to prevent fire risks from unit placement.
Instructions for unit supervision, operator training, and food safety.
Overview of FSD, FSDT, FSD-X, and FSDT-X model configurations.
Decoding the naming convention for model identification and features.
Physical measurements and opening sizes for various models.
Power requirements, plug types, and shipping weights.
Procedures for unpacking, preparing, and positioning the unit.
Instructions for changing the door hinge orientation.
Procedure for adjusting the proximity switch on rotating rack models.
Steps to power on the unit and fill the water reservoir.
Guide to adjusting temperature and humidity levels.
Recommendations for holding times, temperatures, and humidity.
Routine cleaning procedures for unit hygiene and finish.
Instructions for detaching racks and glass panels for cleaning.
Procedures for draining, cleaning, and deliming the water reservoir.
Steps for replacing a faulty LED light strip.
Troubleshooting table listing issues, causes, and corrective actions.
Definitions and meanings of error codes displayed on the unit.
Available display rack options for FSD and FSDT models.
Details on adjustable legs, decals, and decorative kits.
Overview of warranty coverage for products and components.
Clauses limiting liability for consequential or incidental damages.
