58
EMISSION-RELATED INSTALLATION INSTRUCTIONS
“Failing to follow these instructions when installing a certified engine in a piece of
nonroad equipment violates federal law (40CFR1068.105(b)), subject to fines or other
penalties as described in the Clean Air Act.”
“If you install the engine in a way that makes the engine's emission control information
labels hard to read during normal engine maintenance, you must place duplicate labels on
the equipment.”
EQUIPMENT-LABELLING REQUIREMENTS: FUEL LABEL (Chapter 3.5)
The fuel label has to be permanently attached to the equipment.
In case of an engine mounted fuel tank, every engine is equipped with an additional fuel
label.
Otherwise, there are two loose fuel labels available with the engine.
If the original fuel label is not readily visible after the engine is installed in the equipment
then the second loose fuel label must be attached on the equipment in such a manner that
it is readily visible to an average person.
To Next Page
Loading...
