60
Preparations:
• Remove protection guard in numerical sequence 1...4 (B) if so fitted. It is mounted to
the exhaust silencer with three screws.
Dismantling:
• Remove in numerical sequence 1...3 (C).
• For opening screws 1 a special tool is required (HATZ-Ident Nr. 630 815 00).
Assembly:
• Assemble in reverse sequence.
• Apply lubricant as specified by HATZ.
• Torque to specification!
• Ensure gasket-kit is fitted in correct sequence i.e. the creased gaskets 3 face towards
exhaust silencer (A).
• Assemble protection guard if so fitted in reverse sequence 4...1 (B).
• Use anti-seize compound J as specified by HATZ.
• Ensure the concave side of the curved washers 4 face towards guard 3 (B).
To Next Page
Loading...
