For any offer as well as spare parts orders it is
necessary to mention the following data (also
see spare parts list, page 1):
➁ engine type / spec.
(only for special equipment)
➂ engine number
➃ max. engine rated speed
The layout is identical for constant-speed and
variable speed application.
Attention:
If the engine was certified for constant-speed
application and shall be used so, the field "con-
stant-speed only" is marked with “X”.
If the engine was certified for variable speed ap-
plication and shall be used so, the field "variable
speed" is marked with “X”.
Always install the engine for its intended applica-
tion in order to comply with EPA and CARB
emission regulation requirements.
Label 2/2
5b
The engine must be operated with “LOW SUL-
FUR FUEL OR ULTRA LOW SULFUR FUEL
ONLY”.
The label also states the applicable emission-
related power category of the engine.
Fuel label
5c
The fuel label is placed nearby the fuel inlet.
If there was no fuel tank mounted to the engine,
the label has to be permanently attached to the
equipment near the fuel inlet.
3.6. EMISSION-RELATED
INSTALLATION INSTRUCTIONS
See supplemental information for EPA certified
engines, Page 47; resp. supplemental informa-
tion for California regulations for off road
engines, Page 65.
To Next Page
Loading...
