EasyManuals Logo

Hatz 2-4L41C Instruction Book

Hatz 2-4L41C
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
The engine should be in a horizontal position
before adding oil or checking the oil level.
7
Pull out dipstick „1“ (fig. 7).
8
Add engine oil up to the MAX mark on dipstick
„1“ (Figures 7 and 8).
– Run the engine for a short time, then check oil
level again and correct if necessary.
1
L3/45
A
2
1327/2
L3/47
MAX
MIN
1
4.1.2. Fuel
Stop the engine before refilling the
fuel tank. Never refuel near a naked
flame or sparks which could start a fire. Don’t
smoke. Use only pure fuel and clean filling
equipment. Take care not to spill fuel.
All diesel oils sold as fuel and complying with
the following minimum specifications can be
used:
EN 590 or
BS 2869 A1 / A2 or
ASTM D 975 - 1D / 2D
9
– Before the engine is first started, or if the fuel
system was run dry, prime the fuel delivery
pump at lever „1“ until fuel is heard to flow
back through the return line „2“ to the fuel
tank.
Important !
Remember to replace the access cover for the
fuel delivery pump in the side panel of the en-
gine enclosure after priming the pump (Chap. 2).
L3/46
2
1
13

Other manuals for Hatz 2-4L41C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hatz 2-4L41C and is the answer not in the manual?

Hatz 2-4L41C Specifications

General IconGeneral
BrandHatz
Model2-4L41C
CategoryEngine
LanguageEnglish

Related product manuals