Operation and use 2L41C, 2M41, 2M41Z
50
HATZ
Operator’s Manual
2 Code letter on the dipstick
Procedure — Checking oil level/adding oil
Step Activity
1 Switch off the engine and wait several minutes for the engine oil
to collect in the crankcase. Engine must be level.
2 Remove contamination on the engine in the area of the dipstick
(1).
3 Pull out the dipstick and clean it.
4 Reinsert the dipstick.
5 Pull out the dipstick and check the oil level.
6 If the oil level is close to the min. mark, add engine oil to the
max. mark.
For the specification and viscosity, see chapter 4.4 Engine oil,
page 24.
7 Reinsert the dipstick.
To Next Page
Loading...
