Hatz 4H50TIC - Page 87

Type of fault Possible causes Remedy Chapter
The starter does
not switch on and
the engine does
not turn.
Irregularities in the
electrical equip-
ment:
▪ Battery and/or
other cable con-
nections are in-
correctly con-
nected.
▪ Cable connec-
tions are loose
and/or oxidized.
▪ Ground connec-
tion between the
chassis and en-
gine is corroded.
▪ Battery is faulty
and/or not load-
ed.
▪ Faulty starter.
▪ Faulty relay,
monitoring ele-
ments, etc.
Check the electri-
cal equipment and
their components.
Contact Hatz serv-
ice.
3.2.4 Elec-
trical equip-
ment,
page 18
The engine starts,
but does not con-
tinue running after
the starter is
switched off.
Machine is not un-
coupled.
If possible, sepa-
rate the engine
from the machine
by uncoupling it.
Fuel prefilter is
clogged.
Change the fuel
prefilter.
8.2.12
Changing
the fuel pre-
filter,
page 74
Fuel fine filter is
clogged.
Change the fuel
fine filter.
8.2.13
Changing
the fuel fine
filter,
page 77
Fuel supply is inter-
rupted.
Systematically
check the entire
fuel supply.
Faults 4H50TIC
88 Operator's Manual
HATZ