Page 7For technical questions, please call 1-888-866-5797.Item 57720
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Unloading
1. Remove R-Clips (15), Wing Nuts (9),
Plate Washers (10) and Nylon Washer (11) to
remove Ramp (3) from its secured position.
See Figure H on page 6.
2. Remove Ramp (3) and insert the Ramp Hooks
into the Ramp Hook Holes located at the edge of
the Carrier Frame (6). See Figure I on page 6.
Warning! To Prevent Serious Injury: Use two
people to unload motorcycle from Carrier Frame.
Do not drive motorcycle off of Carrier Frame.
3. Have one person support motorcycle to
prevent movement. Have another person
release tension on all tie-downs.
4. Open Wheel Chock Dropleaf (2).
5. Set motorcycle into Neutral gear. With
assistance, slowly push motorcycle down
Ramp (3) and off Carrier Frame (6).
6. Return Ramp to mounted position and secure
with R-Clip (15), Wing Nut (9), Plate Washer (10),
Nylon Washer (11). See Figure M on page 6.
To Next Page
Loading...
