Page 2 For technical questions, please call 1-888-866-5797. Item 62665
Page 3For technical questions, please call 1-888-866-5797.Item 62665
SAFETY OPERATION MAINTENANCEASSEMBLY
SAFETYOPERATIONMAINTENANCE ASSEMBLY
Table of Contents
Safety ......................................................... 3
Assembly .................................................... 6
Specifications ............................................ 15
Operation ................................................... 16
Maintenance .............................................. 24
Parts List and Diagram .............................. 26
Reporting Safety Defects........................... 28
Warranty .................................................... 28
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
VDC
Volts Direct Current
A
Amperes
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking
concerning Risk of Fire.
Connect trailer wiring to
properly fused circuit only.
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator.
Assembly Safety
1. Keep work area clean and dry.
Cluttered, damp, or wet work areas invite injuries.
2. Keep children away from work area.
3. Use eye protection. Wear ANSI-approved safety
impact eye goggles when assembling this Trailer.
4. Do not modify this Trailer, and do not use this
Trailer for a purpose for which it was not intended.
5. WARNING: The cord/wiring of this product
contains lead and/or di (2-ethylhexyl) phthalate
(DEHP), chemicals known to the State of California
to cause cancer, and birth defects or other
reproductive harm. Wash hands after handling.
(California Health & Safety Code § 25249.5, et seq.)
Connection Safety
1. Dress safely while connecting/disconnecting.
Do not wear loose clothing or jewelry, as they
can become caught in moving parts. Wear a
protective hair covering to prevent long hair from
becoming caught in moving parts. If wearing a
long-sleeve shirt, roll sleeves up above elbows.
Wearing safety work shoes is recommended.
2. Do not setup or use this Trailer if under the influence
of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgement or
reflexes are impaired while taking drugs. If there
is any doubt, do not attempt to use this Trailer.
3. Stay alert. Watch what you are doing at
all times. Use common sense. Do not
setup or use this Trailer when you are tired
or distracted from the job at hand.
4. The tail light bulbs supplied with this Trailer are for a
12 volt DC (negative ground) electrical system only.
Do not attempt to power the Light Bulbs with
any other type or voltage electrical current.
5. Make sure the Hitch Coupler and the vehicle’s ball
hitch (not included) are of equal mating size (1-7/8")
and are rated equal to or greater than the
weight of the Trailer and its payload.
6. Before each use, attach the Trailer’s Safety
Chain (1) to the towing vehicle. Attach the Safety
Chain to the towing vehicle’s rear bumper or
frame with equal length on each side and chains
crossed under the trailer tongue. Allow just enough
chain length for unrestricted turning. Do not
allow the Safety Chain to drag on the ground.
Loading Safety
1. Do not exceed the Trailer’s maximum
payload capacity of 1090 lb.
2. Properly and safely secure the payload in the Trailer.
Load the Trailer evenly from side to side
with 60% of the load forward of the Axle.
3. Make sure the towing vehicle and its hitch are both
rated to safely tow the Trailer and its payload.
The towing capacity of the hitch is typically
stamped on the hitch drawbar.
To Next Page
