To Next PageTo Next PageWhat to do if HAUL MASTER Automobile Accessories sway control unit contacts trailer frame when backing up?
If the Sway Control unit of your HAUL MASTER Automobile Accessories contacts the trailer frame or tow vehicle bumper when backing up in a jackknife position, disconnect the Sway Control unit from the tow vehicle before backing up.
Alerts to potential personal injury hazards. Obey all safety messages that follow this symbol.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Used to address practices not related to personal injury.
Used to address practices not related to personal injury.
Keep assembly area clean and well-lit. Keep children and bystanders away from the product.
Stay alert, use common sense, wear safety equipment, and dress properly.
Do not force product, store out of reach of children, and maintain properly.
Only a certified, qualified welder should install this Trailer Sway Control Kit.
Ensure Spring Clip (4) is closed and not bent open for proper tension.
Check for clearance and compression issues when trailer is in a jackknife position.
Road test the unit and adjust Brake Torsional Screw for proper sway control.
Larger or heavier trailers may require two Sway Control units for GTW over 6,000 lb.
Inspect for loose screws, misalignment, binding, cracks, or damage before each use.
Clean external surfaces and lubricate moving parts after use. Do not use solvents.
Solutions for sway control contacting trailer/bumper or insufficient sway control.
General| Brand | HAUL MASTER |
|---|---|
| Model | 96462 |
| Category | Automobile Accessories |
| Language | English |
