To Next PageTo Next PageWhy is the hydraulic pump making an abnormal noise in my Haulotte Group H15SXL Scissor Lifts?
If the hydraulic pump is making an abnormal noise in your Haulotte Group Scissor Lifts, it is likely due to not enough hydraulic oil. To resolve this, top up the oil level.
Why does the machine race when lowering on Haulotte Group H15SXL Scissor Lifts?
If your Haulotte Group Scissor Lifts machine races when lowering, the balancing valve may be poorly adjusted or faulty.
What to do if the platform will not lower on my Haulotte Group H15SXL Scissor Lifts?
If your Haulotte Group Scissor Lifts platform will not lower, it might be because the load in the platform is too heavy (personnel or material). Reduce the load to solve this problem.
Why is platform lifting and lowering jerky in Haulotte Group H15SXL Scissor Lifts?
If the platform lifting and lowering is jerky in your Haulotte Group Scissor Lifts, it is likely due to not enough hydraulic oil. To resolve this, top up the oil level.
What to do if there is no movement with the lifting selector and joystick activated in Haulotte Group H15SXL?
If your Haulotte Group Scissor Lifts experiences no movement with the lifting selector and joystick activated, the selector or joystick may be faulty, or there may not be enough hydraulic oil. Check the movement with the lower lifting selector activated and the machine stabilized. If necessary, top up the oil level.
Why is the hydraulic circuit overheating in my Haulotte Group H15SXL?
If you experience hydraulic circuit overheating in your Haulotte Group Scissor Lifts, it might be because the oil viscosity level is too high. In this case, you should drain the circuit and refill it with the recommended oil. Another possible cause is not enough hydraulic oil, so ensure that you top up the oil level.
Why is the platform not lifting on my Haulotte Group Scissor Lifts?
If your Haulotte Group Scissor Lifts platform doesn't lift, it could be due to several reasons. First, check if the load (personnel or material) is too heavy and reduce it if necessary. Ensure that the hydraulic oil level is sufficient and top it up if needed. Also, make sure that the tilt or slope does not exceed the authorized limit. Finally, check the outrigger cylinders and stabilize the machine correctly.
What to do if the platform will not lower on Haulotte Group Boom Lifts?
General| Drive Speed | 5.5 km/h |
|---|---|
| Power Source | Diesel |
| Turning Radius | 5.90 m |
| Stowed Length | 4.07 m |
| Stowed Width | 2.25 m |
Covers Prohibitions and Potential Risks like falling, electrocution, crushing.
Operator's duties: read manual, report malfunctions, use as intended.
Details test procedures and operations from ground and platform.
Covers principle and procedure for emergency lowering.
Instructions for disengaging drive hubs and releasing brakes.
On-board defect detection system and procedure for faults.
Detailed machine specs including dimensions, capacity, and speed.
