Why does Hauppauge Computer Hardware have poor TV reception?
Poor TV reception with your Hauppauge Computer Hardware might be due to a weak TV signal. If you're using a roof-top antenna, consider using an aerial booster to amplify the signal. Also, if some channels aren't being detected, try manually adding them, or rescan using CABLE (HRC) instead of cable in the Broadcast/Cable box.
What to do if Hauppauge Computer Hardware live TV is jerky?
If you experience a jerky effect or lip synchronization issues during live TV or video playback with your Hauppauge Computer Hardware, ensure that DMA is enabled for your IDE hard disks.
How to fix WinTV2000 display problems on Hauppauge Computer Hardware?
If WinTV2000 shows display problems like a blurred image on your Hauppauge Computer Hardware, first, in the WinTV program group, set the utility 'Primary' to 'Allow Overlay'. If it's already on 'Allow Overlay', switch it to 'Force Primary'. If you have some VGA cards, try to upgrade your VGA drivers from the manufacturer web site.
How to fix poor image quality in Hauppauge Computer Hardware 256-color mode?
If you are experiencing poor image quality with your Hauppauge Computer Hardware while running in 256-color mode, switch to a 16-bit or 24-bit color mode for improved image quality.
General| Category | DVR |
|---|---|
| Model | WinTV-PVR-250 |
| Manufacturer | Hauppauge |
| Interface | PCI |
| Video Compression | MPEG-2 |
| Audio Compression | MPEG-1 Layer II |
| Input Connectors | Composite, S-Video, RF |
| Maximum Resolution | 720x480 |
| Operating System Support | Windows |
| Remote Control | Yes |
| TV Tuner | Analog |
To Next Page
