Haussmann HLG034 - Page 21

gb
21
DESCrIPTIONS, SPECIFICATIONS AND
INSTruCTIONS
Throughout this Operators Manual and the
product itself, you will nd safety alerts and
helpful, informational messages preceded by
symbols or key words. The following is an
explanation of these symbols and key words
and what they represent.
DESCrIPTION OF SyMbOLS
This symbol accompanied by the
word WARNING calls attention to
an act or condition that can lead
to serious personal injury to the
operator or bystanders.
This symbol accompanied by the
word IMPORTANT provides infor-
mation necessary for protection of
the unit or the operator.
This symbol informs the operator to
read the Instruction Manual before
operating this unit.
This symbol reminds the operator
to use eye, ear and head protec
-
tion when operating power equip-
ment.
Hot surface.
Choke control “Cold Start” position
(Choke Closed).
Choke control “Warm Start”
position (Choke Open).
Product certied to United States
Environmental Protection Agency
regulations
!
!
SPECIFICATIONS
Engine:
Displacement:
Single cylinder two-
stroke engine
33 cc
Max power
(Engine speed):
Max torque
(Engine speed):
Idle speed:
Clutch engaged
speed:
Specic fuel
consumption:
Cutting diameter:
Diameter of string:
Cutting string length:
Steel blade
Dry weight
1.1 kw/7400 RPM
1.35Nm/5500 RPM
2800 RPM + 150
4000 RPM
680 g/kWh
450 mm (18”)
1.05 mil
2 m (6.56’)
254 mm (10”)
7 kg (15.4 lb.)
gENErAL SAFETy INSTruCTIONS
To use this tool properly, you must observe
the safety regulations, the assembly instruc-
tions and the operating instructions to be
found in this Manual. All persons who use and
service the machine have to be acquainted
with this Manual and must be informed
about its potential hazards. Children should
be supervised at all times if they are in the
area in which the tool is being used. It is also
imperative that you observe the accident pre-
vention regulations in force in your area. The
same applies for general rules of occupational
health and safety.
When using gasoline powered equipment, ba-
sic safety precautions, including the following,
should always be followed to reduce the risk
of serious personal injury and/or damage to
WArNINg
!