To Next PageTo Next PageWhy is the motor on my Haussmann Saw not running?
If the motor of your Haussmann Saw isn't running, the issue might stem from a lack of mains voltage. To resolve this, inspect the cable, plug, socket, and fuse to ensure they are functioning correctly.
What to do if the cutting disc on my Haussmann TC115I is discolored?
If the cutting disc of your Haussmann Saw is discolored, it could be due to insufficient cooling water. Make sure to fill the product with water. Alternatively, lateral friction from cut runout might be the cause. Try guiding the workpiece through the cutting disc more slowly.
What to do if the motor runs but the cutting disc remains still on my Haussmann Saw?
If the motor of your Haussmann Saw runs but the cutting disc remains still under load, the flange nut might be loose. Check that the flange is seated correctly and tighten it if needed.
How to fix irregular running/vibrating of the cutting disc on my Haussmann TC115I?
If the cutting disc of your Haussmann Saw runs irregularly or vibrates, it could be due to a warped cutting disc. Replacing the cutting disc should solve this issue. Another possibility is that the cutting disc is fitted incorrectly; ensure it is properly installed.
Visual indicators of potential hazards and required precautions.
Essential safety instructions for safe operation and handling of the tool.
Safety guidelines for operating the tool and maintaining the work area.
Safety precautions to be followed during servicing and maintenance of the tool.
Specific safety advice related to the operation and use of this particular product.
Guidelines for safely storing and transporting the tile saw.
Precautions related to the electrical connection and grounding of the tool.
Recommendations for using safe and appropriate extension cords.
Procedures for unpacking the product and verifying contents.
Steps for attaching the rubber feet to the base of the tile saw.
Instructions for fitting the diamond disc and securing the metal bracket.
Guidance on how to install the protective guard correctly.
Steps for attaching and using the parallel guide for cutting.
Instructions on how to properly fill the water tank for operation.
Guidance on connecting the tile saw to the main power supply.
Instructions for safely starting and stopping the tile saw.
Procedure for performing straight cuts on tiles.
Steps for making angled cuts using the mitre guide.
Instructions for cutting tiles at specific angles or bevels.
Guidelines for cleaning and maintaining the tile saw.
Common issues, their causes, and corrective actions for the tile saw.
Instructions on how to register the product for future communications.
General
