• 03 •
Install the protective bottom plate
Installation
1. Take the bottom plate out from the
package.
2. The plate is to be installed from the
front of the bottom.
3. Insert the plate by pushing it all the
way in.
4. Lay down the machine and fasten the 2
screws.
Place the washing machine on a
flat surface and at least 2 inches
/ 5 cm away from the wall.
Adjustable Foot
Screw Adjuster
Nut
5 cm
Use the adjustable foot to perfectly level the
machine.
1) Turn the nut as shown in the picture to release the
screw adjuster.
2) Rotate the foot to raise or lower the machine.
3) Fasten the nut by counter-turning to lock the foot.
Properly place the washing machine
Connect the water supply hose
Connector Nut
Rubber Ring
Water Valve
1) Connect the curved end of the water supply hose to the
water inlet on the machine (near the top lid on the back)
and fasten the connector nut. Do not detach the
waterproof rubber ring.
2) If the water valve or rubber ring is damaged, please
contact us for advice on repair.
To Next Page
Loading...